Recent content by ExaminerNick

Ok thanks anyway, I’ll speak to them on Monday.

Hi again. I contacted my alarm company and they have adjusted the pir to auto mode remotely to see if that solves the problem. I’ve just walk tested the sensor and it’s behaving differently compared to when it was in Hybrid mode. In Hybrid mode the sensor would go green when it picked up...

Thanks for your advice, I’ll get on to the company who installed the system.

Hi. Ah yes that makes sense that red is active. They replaced like for like, the first sensor was false alarming even with the sensitivity turned down. However I suspect the first PIR had been set up incorrectly and not in hybrid mode as we hadn’t seen “preparing to arm” until the...

Hi. It’s wireless and in the integral garage, not on the exit or entry route and immediate alarmed on full and part armed.

Hi. I recently had a texecom wireless dualtec sensor replaced by the company who installed my system and they have set it up using hybrid mode (I know this as my keypad now says preparing to arm). A couple of times now when I’ve gone to set the alarm from the app it won’t set because this new...

Thank you Muggles. Fingers crossed he was a good Pro!

Hi there! I'm new to the site and apologise in advance if my query has been dealt with before. So I have a 3rd Generation Nest installed by a Nest Pro installer. Prior to the Nest installation I had a standard combi boiler in the bedroom with a programmer in the kitchen and a thermostat in the...