Recent content by F4ranky

Your valuable advice is much appreciated. Thanks

Hello to all fellow members. I am dealing with a problem with a Valor Eminence Model Gas Fire. It developed the fault gradually as I have tried to explain in the following; Initially, it failed to ignite pilot flame despite replacement of new batteries in its receiver and remote control. I was...

I am pleased to let everybody know that I have resolved the problem successfully by using this platform. CROSS THREAD & CBW who have jointly guided me to root cause of the issue and how to check it respectively. There was a Loose connection to an oxidised live lead to thermostat from the...

No,I haven’t. Would you advise me what is the best process to check the continuity of the thermostat please.

Yes there is a thermostat. I have tested the junction box with thermostat on ie maximum temperature position.

Hello to all. Central Heating cooled down a few days ago, the diverter valve Drayton ZA5 controlling central heating appeared malfunctioned. I have tried to operate manually but did not remain on. I removed its head and turned the central heating on by opening the valve manually whilst Hot...

Firstly I would like to thank fellow forum member Yardie who helped me throughout in resolving the problems with my Creda dryer. Secondly I would like to update you now. I checked the front thermostat and drying sensor, both of the component were found functioning satisfactorily. After having...

Its heater definitely does not turn on. No, sorry I have not managed to locate the exhaust stat and drying sensor yet

I have connected a flexi hose pipe and feed it into the washing machine drain pipe but during all of the currant repair procedure I have have left the flexi pipe into a bucket on the floor as the dryer is placed on a shelf above washing machine. I have tried it twice with cloths on sensor...

I have tried it at the sensor setting loaded with cloths taken out of washing machine. It ran about 55 mins. At the end cloths were nearly dry but cold the heater did not turn on throughout the cycle. I have checked the water tank overflow sensor. The machine halted when its overflow sensor was...

Sorry I am at work at the moment. I did not get a chance to try at other setting with damped clothes loaded in. I will try later on after the work and let you know the outcome. It did not have any problem with heating. In fact the element was glowing red hot whilst I was resolving the motor...

Thank you very much for your advice. I will try tomorrow and let you know the outcome.

I have been trying at 30 mins drying programme. I will try it at other modes tomorrow. i can not turn it on now because my because my two years old grand children are asleep now. I will try and let you know tomorrow

Yes it is sensor dry.

Yes it is condenser dryer. Where is the exhaust thermostat located?