Recent content by farenheit

No dripping taps.

Definitely. I can also hear it firing up every now and then, as I type this message. You can see this link regarding the usense and the option to switch it off.

Does anyone know how to switch off the preheat on this boiler? Baxi customer service haven't got the foggiest and asked me to check my thermostat lol!! You can switch it off via the baxi usense but I'm not going to fork out for this kit just so I can switch off the preheat. I'm hardly in and it...

Just to clarify though, it only condenses when the heating is on right? So if it's leaking, say overnight with the heating off I should catch it in a bag.

The condensate pipe goes out and into a drain. Haven't seen a leak near this inside and I've had a quick glance on the outside of it and it doesn't seem wet however, to give it a thorough check I would need to remove the insulation unless I'm looking in the wrong place? We're exactly should I be...

That's what I've done (sorry I called it a blow off pipe lol). Seems empty and dry to me. Will check again today after work.

About approximately a month ago I had a baxi 636 installed. This replaced my trusty ariston microgenus lol. Anyhow, I noticed with this boiler the pressure keeps dropping approx 1/4 bar per week. Initially I thought the boiler is just settling down, air etc, but after the second week I thought...

Hi Roy I was hoping you could help me with a similar issue. I have wired my baxi 636 to a Drayton opentherm, however I have noticed I am unable to change the water temperature or the central heating temperature. The water temperature is scalding hot and was wondering if you were able to change...

Anyone in the brummy area fancy doing it

Which one is this please? Do you have a link so I can read into it? It’s not the temperature probe is it?

Hi all I have the above system, I know (old and not the best) however it has served me well, considering it was already fitted in the property when I moved in. Earlier this year I had the main and secondary heat exchangers replaced by British Gas (long story - they didn’t need changing but as...

Thanks Last question, would I need to isolate the cold water supply?

This is why im asking before i botch it up lol.. Cant i just drain the whole system instead to save myself this headache! Just refill later with inhibitor?

The instructions from Rob above did say to close heating return valve.

Ok i think ive sussed it. Can someone please confirm that i have the correct valves highlighted in the attached image. Thanks :)