Recent content by fitz1

maybe, I think its a board problem.Probably been damp lying there unused for a while.I was wondering if it could be the condensation sensor but im sure if it was the boiler wouldn't fire at all

all is fine,its firing then not rectifying then tripping.Reset,same again. Theres continuity rfom probe to board

its Been in empty house for a month or two.Now lights on both heat and hot water but trips out .Spark continues while burner lit until trip out after approx. 5 to 10 seconds. .

Not sure but think gas ran out, subsequently boiler gets to one spark and trips out , one per second. Linked low water pressure switch but still same. Going back with tools mon. Any other faults on this boiler that throw you. cheers.

oil light came on after long drives. think the oil was thin. new oil and filter yet still coming on while running idle .

explosive ignition.what order to check(any common fault)

go through it and look for pressurising(filling) system

dont touch that. do u have the instuctions for the boiler

sorry didnt read the heading. under the boiler is a plastic cover. remove and have a look on the back. is there a plastic key

what boiler is it

first fix pipework before tiling and fit toilet and basin after.i would suggest an electric shower of the mains water. you can get a speedfit(pushfit)blank from any plumbing merchant.I would advise you to seek advise from a qualified , reputable plumber.(on site)

fill back up system to approx 1.25 bar, see what happens.

whats the kane may km800 unit like. any good.

anyone had a gas safe inspection. ive got one in july.are the old corgi inspectors working for gas safe.

could be something to do with your flow rate and min gas pressure setting. get the rgi back.