Recent content by FlyingDragon

Hi all, some advice and suggestiions please. If you could refer to the attached image to make things clearer. I have removed old silcone and some ceramic beading that was fixed around bath, as water was getting through and black mould forming. I disliked the beading anyway, and prefer a nice...

Unfortunately it's a once piece profile and there isn't a way to remove that U section, without seevere damage. Anyhow, I've just drilled a hole and found the screw. Thanks.

I took a chance and carefully drilled a hole 15mm below keyin line, into PVC, where a grub screw would normally be in the cylinder. It was there but had to drill further to the right as it wasn't in the complete centre. Thank you all for chiming in. Its a 80mm, so I've ordered a multTlock...

I've looked, but hardly any space to look through. even if shining lightfrom other side but I can rock the cyclinder like a see-saw a few mm, feeling that there is indeed something holding it down in the middle, creating the pivot.

I was thinking that too, but wondering whether it comprimises the security as most newer doors tend to have a plate in front to hide the mech?

That in line with the euro cylinder, there is no grub screw access, if there is one.

Hi all, new here. Before posting a question, I've trawled through the many many questions and answers about euro cylinders but cannot find a definitive solution for mine. I have a PVC door with a euro cylinder, its been fine for several years. Lately its been giving issues, with old and new...