Recent content by garnet

Appreciate your concern here. I will probably call a sparky, but I really can not see what the issue is here and that drives me nuts. I will test the circuit from MEM switch to each lightfitting and between the lights with multy meter and with the main fuse removed. If there is not connectivity...

With one of these

This is getting even more weird. I opened the MEM switch. There is a 20A fuse in there. Also blown. Will rewire it. In the meantime I connected the terminals of the mem switch fuse with a bridge wire and set the photocell to test. Still no lighting. I can see current to the upper terminal of the...

I will check that.

I dont know if it privatelly owned, but there is a separate live cable coming from the ground to it. So I guess it is Energy supplier's - or the council - this used to be council building.

Hi all, All is very strange. the gray cable on the top of the meter goes to intercom electronics. They work OK. I dont see where the cables go so they can supply the lights, but I guess lights wont be supplied through the intercom electronics. The BS88 fuse was blown. I did change it, it works...

4 lights fittings in the building. Fuse doesn't blow at the moment. I would expect it to blow immediately if something was wrong with the fixtures.

Hi all, this is about a stairwell lighting in one block of flats. The lights are on a light sensor, which turns them on when it gets dark outside. About a week ago lights stopped working. I took a look at the fuse board and found a blown fuse (16A) on the circuit which leads to the light sensor...

I was stuck valve (the vertical one).

What is AAV?

No, no pressure gauge. I think this is open vented system - is it not gravity fed? There is no upstairs - it is a flat. One flat above and the loft.

Thanks. So we are narrowing down this issue to water refill of the system. Is this done at the cistern at the loft?

This is the whole installation top and bottom. Question is now with this Spartan, is it a purely lack of water issue or stuck valve?

I don't think it is electrical issue. I have that. I don't know if there's a cistern in the loft as it is locked. There is a pipe going though the ceiling. Does that mean anything?

From 0 when the heat is called for, the boiler burner starts. 2-3min later it stops as it has heated all the water in the heat exchanger and the pipeworks to the pump (1.5m away). Do we still think this is the valve? Something started the boiler in the first place - isnt it the valve?