Recent content by gary1974

I'm not experieced enough to do that :oops: Will do as you suggested I think.

thanks, just had a look at its a 70va one. So, should i basically just replace all the bulbs so they only reach that voltage? Had this tranny for 7 years though, why would it just cut out now?

4 in total, 2 hallogens on sticks and 2 light up the 'cabinet'. Not sure of all the wattage - checks... ....the range from 20watts to 50watts.

I have a set of halgoen lights on 'stems' in my kitchen - and suddenly one half of the kitchen has gone out - I'm looked at the top where all the lights connect and see that attached pic (I've since opened it) If I press on this (when the casing was on obviously) the lights would come...

I've noticed recently that my Central Heating pressure has been dropping a bit and whilst cleaning a spare room noticed that one of the radiators was leaking (the carpet around the main pipe going into it was wet. As it's not the usual side of the radiator I would have thought to have leaked...

Thanks. Will do that.

It's all fine now - however - I cant get the legs to balance so it always tilts slightly when I open the door? Does the door need adjusting - or the legs? I've tried to adjust the back legs as per the manaul - but they hardly move...the front ones move no problem!

Hi I've recently installed the above dishwasher - however I've yet to install the kitchen fitted door to the front of it...however - the door wont stay open at the moment and springs up sharply - so much so that I had to hold the door open with my foot to empty it with a test run tonight...I...

I'm happy with the fact it has to go into the connection plate..but it was advice or pictures to remind me of the wiring is what I need thanks!

Hi I'm getting a new integrated dishwasher which wires into the wall rather than a plug. Can anyone advise of the correct wiring..I took a digital photograph of the previous wirings but any help would be great. :lol: