Gasguru's latest activity
-
GGasguru replied to the thread Advice on mains flow rate.Be aware that many meter adapters have single or double checkvalves built in. I don't know whether they are accessible to clean out but...
-
-
GGasguru replied to the thread Fitting WRAS stopcock and pipes.Google wras incoming service pipe Normally the pipe should be within an insullated duct.
-
GGasguru replied to the thread Chimney insulation.Stick a C Cap on the pot. I'd run a short bit of overflow pipe up the flue and ram rockwool around it. Small vent on the plasterboard.
-
GGasguru replied to the thread Any advice?.Silicon grease the threads...
-
GGasguru replied to the thread Baxi duo tech constantly heating.GSI&U regs don't mention anything about combustion chambers....Section 2.1 defines the whole boiler as a fitting. Any prosecution would...
-
GGasguru replied to the thread Baxi duo tech constantly heating.That's irrelevant when it cones to working for gain.
-
GGasguru replied to the thread Baxi duo tech constantly heating.Gas... we've had plenty of illegal workers on here asking questions. Indeed, I now see he's using a wireless Salus timer/stat so the...
-
GGasguru replied to the thread Baxi duo tech constantly heating.Are you registered? I now see that you mention replacing the thermostat/timer/receiver but the factory link is still in place. The...
-
GGasguru replied to the thread Advice on mains flow rate.From the UU point of view there's nothing to be done...9 litres/min almost certainly complies with their minimum requirements..on my old...
-
GGasguru replied to the thread Advice on mains flow rate.It's pretty obvious to see the difference between 9 litres/min and 20 odd litres/min but surely it's not beyond anyone on here to...
-
GGasguru replied to the thread Advice on mains flow rate.The blanking cap is where a water meter would screw on. Turn off the water and have a look under the cap (open a tap to relieve...
-
GGasguru replied to the thread New boiler and gas lead pipe.I'm not arguing with your petty interpretations. For the OP the meter should be attached to the wall... or floor...
-
-
GGasguru replied to the thread New boiler and gas lead pipe.Don't be an ar5e...you can plainly see a meter swinging on a flexi and old lead pipe is unsafe and G11 3.11 makes reference to poorly...
-
GGasguru replied to the thread New boiler and gas lead pipe.The meter installation is classed as "At Risk". This is an industry standard category and it should not have been left "as is" without...
-
GGasguru replied to the thread New boiler and gas lead pipe.Are you happy to be part of his conspiracy to evade tax? It might get very awkward should the job go wrong and you need to issue a CCJ...
