Hi I have put a new booster shower onto my hot water supply. I have installed it just above my hot water cylinder. The pipe work then tees of to my bathroom and kitchen and the other side of the T goes back upstairs to my cold water storage tank. Question is when i put the hot tap on there is...
Hi thanks for your help
its a british gas boiler i know a bit more today i have tried to bleed the pump but there was no water coming out when i bleed it so i cracked the fitting into it and there is no water coming from the header tank to the pump (well i assume it should come from the...
Hi
I have had my boiler turned off to replace a radiator and refit my bathroom suit. When i have turned the boiler back on the boiler is going into fault. I have looked at the pcb inside the controls and the LED display tells me that the pump has over-run any ideas why this is happening?
stem wrote:
The usual method of installation is to run a cold feed from the same storage tank that supplies the hot water cylinder. That way, the hot and cold pressures are more or less identical. You can boost both with a twin impeller pump if required.
Thanks for that.
I...
Hi i am installing a new thermostatic mixer shower and was after some advice> At the moment i have the cold water to my bathroom straight off the mains which is about 4 bar and the hot come from a cylinder feed via a header tank which is at low pressure.
Is it possible to put a pressure...