Recent content by Gazzae

OK I'll get my info together, it might be middle of next week now, with work and family commitments, but it's all simple really, are you familiar with the arduino platform, and using AT commands for gsm?

Ok I'll get some info together and send it to you, can you pm on here?

No worries secureiam what would you like to know?

I built an arduino sms system for my texecom panel using a gsm shield, I'm using giffgaff at the moment and all seems good, I have it programed to send an sms to two different numbers when there is an alarm event. I'm working on voice notification at the moment, but all working good so far. Only...

Yes can see it on the network, my bt home hub can see it also as it tells me it is connected to it, I have given it a fixed ip address in the home hub and opened port 10001 which is definitely open, but when I put that ip address into my browser while connected to my router I can't connect to...

You can connect to comwifi directly, just like you would when you first set it up, it shows up as "comwifi" on your wireless network, so basically I disconnect from my router and connect directly to comwifi, this is fine for using it at home, but no good for push notifications etc when out and about

Sorry sparkymarka, not sure what you mean?

If I connect to comwifi directly (not through router) all is ok, just can't access it through the router.

Hi cchiris, I'm not quite sure I understand what your saying. Can you please put it in layman's terms for me! Thanks.

OK have checked that port 10001 is open and it is, if I ping the ip address assigned to it it cannot see it, even though it's clearly set up in the router for com wifi. If I connect directly to com wifi I can do everything, connect through wintex , use ricochet monitor etc, this things driving...

Hi I'm having issues connecting to com wifi, if I connect directly to the com wifi using the laptop its all working as it should, I just cant connect through my router, I have checked the IP address and port forward over and over again my router even says that com wifi is connected to it, I just...

Thanks chaps.

So just enter engineer code? Thanks for quick reply!

Hi Is there anyway I can temporarily disable the lid tamper on my texecom premeir, I need to fit my com wifi and don't want to wake the kids! I only get the evenings to do the work.

Just an update on this thread...... It has been confirmed that the pir was faulty, after programming the replacement pir to the system all is good, fortunately the neighbour over the road has a ricochet system the suspect pir failed on his system too.