Recent content by gibs

Thanks for the advice.....with regard to the floor, I had to rip up the old floorboards for access to do the piping etc...this was replaced with chipboard and overthis a thin layer of ply to provide a more even finish. the bathroom floor has a dip in it as is quite common where a main floor...

I am a one man band , a jack of most trades(a master of none..thought i'd get that in before you lot could..) I do a good job for low prices and am an all round good egg...unfortunately recently I have come up against a complete TO..ER! for whom I fitted a complete bathroom. I wont bore you all...

yes, only the one tap causing problem...unfortunately the bath tap is of the mock victorian type...the one that has the shower attachment like a phone on top! so the tap is very wide. I have taken the cold tap valve out and the water dribbles out ...any suggestions on how I can get round this...

Hi all, I recently replaced my bathroom taps both bath and wash basin, to do this I simply turned off water at mains and allowed the hot and cold taps around the house to stop flowing...upon changing the taps in the bathroom the hot works fine on the bath but the cold is just dribbling, hardly...

I will change them.....to what??? any suggestions? thanks

Hi, I recently replaced my old mixer tap in the kitchen (very old) for a franke mono mixer tap, the new flow is very poor. at first I used flexi pipes but changed them to full bore 15mm, but the flow is still poor. The hot flow is not brilliant but it was much better than it is now. looking at...