Hi Folks
Anyone know if a circulating pump can be put on the primary flow or return circuit to improve the flow.
The pipes come out of the stove, rise a few inches before dropping a foot, then pass through the chimney breast before rising to the first floor invented cylinder.
I’m aware this is...
Evening folks, Got a bit of a headache trying to figure this out.
Blue pipe incoming mains - stopcock - prv - 2 external garden taps one front and one rear. Prv is reading 2.6 bar. Confirmed this with a meter on the dishwasher feed. One garden tap reads 2.6 bar. The other 3.7 bar. How can this...
Hi Gents,
Is it possible to drain the coil without the rest of the upstairs heating system. Cylinder is located in 1st floor airing cupboard with the boiler underneath on ground floor.
Leaking soldered joint shown in green directly below air bleed vent.
I need to fix it.
Any help much appreciated!
I have an option to buy a used Fernox PowerFlush Machine MKII and 2 MagnaClean Filters for £850. Have you heard any problems regarding these machines. If I opt for the Kamco I'm looking at £1500 new with a magnaclean filter.
Cheers
Gents. Thanks for all your help. I am not a heating engineer and am at a loss to know what I can do next. I thought the cold feed is from the F&E tank. All the rads are full of water. How is this stopping the rads downstairs getting hot?
Ollie. If only life was simple. Downstairs rads cooling down since I opened up the top rads. Off to price a job. This heating system is driving me nuts.
Hi folks! Anyone good at problem solving.
I have a traditional open vented, pumped Y plan heating system. Put cleaner in the system a few weeks ago to stop the kettling coming from the boiler. Drained down a couple of days ago refilled and added inhibitor.
The problem - I have hot...