Recent content by GTA

Thanks for explaining Rocks

Sorry, I am getting a bit confused now. The list is on about lights 1 to 4 but there are only two. The on/off power light and the heater light. It's the first one that flashed twice every 10 secs. You said earlier that f02 was motor triac (whats triac by the way). The list says f02 is...

So your saying new printed circuit board required. On the Indesit web site it just shows error codes f10 to f51, where do you get 1 to 10 from.

Hi Rocks The PCB must have been confused last night (just like me) The symptoms have changed. When we tried it again today it fills with water but misses the wash cycle. The programme dial spins and the red light flashes twice. It spins, rinses and drains ok Cheers

The door locks ok. It doesn't fill on rinse or work on spin only. When programme selected and start button pressed it doesn't fill, after 5 secs the programme dial just spins endlessly and the red light stays on permanently.

Thanks rocks I have checked the brushes. They look ok, there is about 3/4 inch of carbon left. I know it means nothing but I have checked the PCB and it is bone dry with no sign of any burns or damage. Do you think the inlet valve/solenoid is the probable fault. By the way I rang...

Does it not fill with water before it starts spinning ??

My Indesit WD12 is not filling with water. The handbook says the AUTOCLAVE might be malfunctioning. I rang a local spare parts dealer and they have never heard of it. They say it might be the inlet valve or solenoid. Has anybody any ideas ?? Thanks

When a programme is selected and start button pressed it doesn't fill with water. After 5 seconds the programme dial starts turning round and the red warning light stays on permanently. There is a water supply to both inlet hoses. Any advice would be greatly appreciated.

When programme selected and switched on the programme selector switch keeps clicking round and the drum doesn't fill with water. Anybody any ideas, I,ve noticed on various forums that plenty of people seem to be having the same problem but not many answers forthcoming. Thanks