Here's a diagram of my setup, i'm wishing to either put the pump in Location A or B....... putting the pump on the bolier return pipe is not an option due to pipework location......thanks again to chris, bster and agile.
Mike
as far as i can see i just have the f/e setup on the delivery side of the gravity HW circuit about 10 ft before the HW cylinder, is it the general consensus that the pump should go after the f/e setup or before....sorry for all the questions...
Thanks Guys.
Mike
:D
Thanks Bster, so if i install it close to the HW cylinder which will put it between the cylinder and the f/e pipework, this should be okay..? Iwas concerned if i put the pump before the F/e tank as per Agile says, this could possibly push water into the f/e tank...... :? :? :?
Mike
thanks agile, can you explain the reason for this...?
ChrisR..I thought this would speed up the heating of the hw cylinder..? is this not good practice, i have feed on other posts about people doing this..?
Thanks :?
Hi All 1st post
Im about to install a Milo pump on my Gravity fed HW circuit, is it better to put the pump after the F/E tank pipework or before...?? I Ideally would like to mount it close to the HW cylinder (after the F/E tank) for easy installation..any thoughts recomendations..?
Thanks Mike