Recent content by Hendel0

I have just taken a look behind, I think you located the problem, Jesus it’s a mess. God knows how it has worked at all ‍♂️

These are my options, I don’t have a 1 and 6. I have tried removing link A and the HTG to T and DHW to W.

I tried that initially and it tripped the RCD?

From Hive Our receivers are supplied from mains (the permanent live and permanent neutral connections). The single channel receiver has “dry contacts” or “zero volt contacts”, that means it acts like a switch connecting the signal input terminal (shown as “Common” in our install guide) to the...

Yeah that caught me out initially. The problem I have is the boiler runs on a low voltage (dry contact) switch but hive works on wet contact so I believe, so do I wire it into the existing controller I.e. run the normally open in to the common on the controller?

It’s a Trianco FS EuroStar Combi 50/65 Eco

It has a water tank built into the boiler (it’s oil fired) so wanted to control that also

Hi I have purchased a Hive dual thermostat. I’m trying to install it into a Trianco Combi boiler. Has anyone successfully done this?