Recent content by highmcdiy

Will see what it's like once I get it insulated I guess. I have a remote monitor so will see when the heater comes on

One of the aims is to keep it heated though. Only at around 15 degrees though. The temperature currently goes down to around freezing.

The goal is to keep the garage at an ambient temperature and reduce humidity. The humidity in my area is very high so there is a chance the humidity will rise in the garage. The garage has two up and over doors so some air will get in there. There are 4 airbricks letting loads of humid, cold...

Thanks Woody, I will just go for it tomorrow and constantly monitor humidity levels.

Do you think I should just finish the insulation with the PR boards and just put in an extraction fan on the roof then?

It does help a bit, maybe I am over worrying! Although in my garage right now it's 4 degrees Celsius and 87% RH

The more I research this, the more confused I get. Was thinking about some sort of trickle vents high on the wall, maybe 4? It's a 5m x 5m garage. Not sure what to use in a stud wall for this purpose. Plus I have permeable membrane on the outside of the stud which I would need to cut through...

So no passive intake vent? Or passive intake vent and this?

Just an electric heater, it's just for storage and possibly a workshop at one point. Temperatures get down to freezing at winter.

Thanks for your feedback Woody. The goal is to keep the detached garage relatively warm, reduce humidity and dampen sound. I am looking to store stuff in there and might put in a partition wall and make one half a workshop. My main concern is if I seal the garage there is no-where for any...

Hey woody, the garage was built with the airbricks - I believe that is because of building regulations? They have put 2 at a lower level at the front and then 2 at the back higher up. My interest is the ventilation within the insulated studs though. The garage humidity level are around 80RH at...

Hi guys, I have insulated my single skin garage by putting up a stud wall in between the pillars of the garage. I have been advised that I need to add ventilation to prevent the build up of humidity inside the garage. The garage will be kept at an ambient temperature. There are 4 airbricks...

Thanks for replying - I appreciate your input. I am using it for storage so it will be kept at an ambient temperature. The humidity in the garage is very high due to weather conditions. I have a DPC running underneath the studs. I am asking in here as I am not experienced at building...

I am thinking of creating 2 studs either side of the electrics and bracing them with a header plate. That way I can fit the membrane and they will then fit in the space, almost like creating a door opening. Any thoughts? Is this daft?

I did consider that but it's single skin and there is a small risk of moisture ingress so thought this was the best way to go.