Recent content by Higuys

Thanks again, I don't do gas so I was going to get someone in but I wanted it working over Xmas as I am currently switching the boiler off at night and when I go out. I can't get a board locally so am relying on the post to get it. Your reply has convinced me to wait until after Xmas before...

Thanks for the speedy reply you are a credit to the forum, I was expecting the PCB to be pre-set to the correct parameters so why does it need adjusting ? Could you tell me what will happen if I just change the board without adjustment and also what the settings should be if I can get hold...

Hi there, I have a 7 year old 100E combi boiler and think the PCB is faulty. The problem is that when the CH is on the hot water solenoid on the PCB starts clicking quite loudly you can see the contacts fluttering making the noise, turning the hot tap on stops the fluttering for a...

Hi there have been reading all of your advice regarding fitting worktops and decided to try it myself, I bought a silverline worktop jig along with an 1850 watt router and TCT cutters Now the problem, the radius of the male section is a different radius to the female section, when offered...