because i didnt know what was wrong to start with.
the fan is a mechanical part.
i wouldnt mess with the airbags on my car, but i would change an oil filter
so if i can just swap a part out without going near anything technical, i will.
but if swapping that part requires me to do a...
thanks guys.
im not planning on touching the thing myself. but it would be a good if i could get some idea of the issue before calling someone qualifies to have a look and give me a nice bill.
i told the wife to turn the dial down to 12 oclock. it was at about 4 oclock.
that appears...
hi all
i have the above boiler and as of the weekend we are stuggling to get anything more than luke warm water out of it.
the boiler fan kicks in, then the burner light comes on for about 10 secs. the light then goes off and take a couple of mins before it comes on again for another 10...
thanks for the reply noseall.
my garage floor is 130mm below the kitchen floor, i the largest k3 boards i can find are 80mm.
what do i do?
50mm of screed?
stack 50m of kingspan?
revert to standard joists with kingspan inbetween?
im about to start converting my garage which currently has a concrete floor.
if i was to use kingspan k3 floorboards, do i need to put a membrane down before/after and do i need to lay a chipboard floor on top, or just screed it?
thanks
cheers mate.
im guessing the garage will be a single skin, any idea what the cost would be around...
ive read anything between £500 and £1000 per square metre?
this very similar what im thinkin of doing, so any info would be greatly appretiated...
i wish to build about the garage and kitchen, a bedroom and ensuite.
house is in the northwest of england and i think the approx size would be about 25m2
cheers