Recent content by Houman

Hey guys, I did it! I wanted to thank you all for participating and helping me. The price goes to mattylad. I used a 3mm flat head screwdriver. But it was a tad too small. 4mm may have been better. I had to be very careful going at a very low speed. The funny part is I went to Wickes...

That sounds like a last resort idea. I like that. Thank you.

No, it doesn't have to come out. It has just to go in. This is a solid idea. I'll try that. Thanks

Yes, I gave up on the idea. There is also a picture there that says, not suitable for double head bits. Hence it won't fit. Just to test the hole size in the screw, I picked right-hand bits into my hands (no drill) and slowly inserted into the hole. 4.5 mm diameter is ok, but 5mm seems to have...

I didn't order it yet. :)

You mean in order to use the screw extractor? Indeed this is also a possibility. I just checked on Ebay and the extensions are coming from China and won't be here by mid-Jan. But I found this. Thanks

Ah sorry, one more thing. When I try to buy it, it needs the diameter. These screws are M4 x 40. What diameter do I pick? Thanks,

Fantastic. Thank you so much! I will get those bits now.

Thank you. I have a reverse drill already. Could I just reverse it with a usual drill bit into it? Probably not... And if I bought the left-hand drill bits, do I then reverse or simply drill as usual?

Hi, I don't really do a lot of DIY jobs, but I have some tools and get the job done if needed. I have recently purchased these dining chairs from Made.com and had big trouble assembling it. I made a mistake picking a screwdriver that wasn't large enough. My drill has ruined one of the screws...