Recent content by Ian2008

  1. I

    EV Charging point - doing it properly?

    Comes with both mode 2 and mode 3 charging cables. both stored in the boot
  2. I

    Which connector on this key switch is which?

    That is a generic switch for a diesel engine. NO 1 + feed in NO 2 Ignition Connection NO 3 Heater plug connection NO 4 Starter connection
  3. I

    best way to raise a belfast sink 6mm to meet quartz worktop

    Sit the sink on a piece of 9mm plywood cut to match the sink footprint.
  4. I

    Camping extension cord recomendation 1.5mm or 2.5mm

    Why not just buy a purpose built tent hook up like this? http://www.winfieldsoutdoors.co.uk/sunncamp-deluxe-mobile-mains-supply-unit/?gclid=CLTulbvm7csCFUieGwodDY4OkQ
  5. I

    Boat cable size

    That's right. The engine block etc need to be bonded to the met.
  6. I

    Boat cable size

    BS EN ISO 13297 ac instalations in boats insist that the engine etc are bonded. So a galvanic isolator Is a must. You only need to be moored next to a boat with a bad instalation and be pluged into the same point to have your prop, rudder and other underwater metalwork eaten away surprisingly fast.
  7. I

    Consumer box - replace 16amp with 32amp

    Nope that won't work. If the saw trips a 16A mcb then the 13a fuse in the plug on your extension lead will blow.
  8. I

    DREADED IDEAL BOILER

    (y)
  9. I

    What's Your Real Ale Name?

    Cloggers Hoppy Cock Slurper Oh Dear :oops:
  10. I

    wind power

    You don't want a dc motor what you need is a 12 volt alternator from a car. No need for an external regulator or battery charger as it is all built in.
  11. I

    Oxy/Act Portapack

    BOC bottles are require a yearly rental charge and unless used regularly get expensive. Try Hobbyweld.co.uk stockists in your area. No yearly charge just a one off deposit then pay for refills. I have done this and it has worked out cheap.
  12. I

    vaillant 831 pressure loss

    Last line of the op text. .im sure the insattlers did flush the system out before they fitted my boiler about 3 years ago, they also fitted a magnaclean in the system...cheers
  13. I

    correct bayonet cooker hose?

    Your gas safe registered engineer will be able to supply this for about the same price. That hose is for natural gas not LPG is that correct? However there is more to installing a cooker than putting on the hose. There are several checks to carry out when commisioning a cooker and your...
  14. I

    Gas cooker to dual fuel bayonet & location

    In answer to your question yes it is impossible to install that cooker with the bayonet behind the cooker. The manufacturers instructions are specific in the location of the bayonet. It shouldn't be a major job for a gas safe registered engineer to move it for you. Manufacturers instructions...
  15. I

    rusty radiator help

    As a temporary fix turn off both radiator valves( one each end) Then it won't leak anymore, when you have the time replace the radiator.
See more
Back
Top