So it looks like the boiler isn't lighting. Do you know how I could possibly get it working? At the moment I'm looking at section 3.3 on page 21 of the manual. Thanks
With CH and HW set to be ON via the Potteron EP2000 there is no flame icon.
See pic: http://s3.postimg.org/kx21ddab7/WP_20141005_004.jpg
Note the new radiator wave icon. I also noticed that the 16C has gone up to 18C. Not sure if this is since turning the HW and CH on or since this picture...
Have changed programmer and now the CH and HW is selected to be on constantly. The display remains at 16 however I have made sure it's on 70. I assume the 16 is the current temp and the 70 a target temp. The radiator icon now has a flashing wave above it to indicate heat coming from the...
Yeah it seems OK. It was all working fine before the water heater switch was flicked. Turning on CH and/or HW causes the boiler to make some normal sounds as if it is operating, but no hot water or heating comes out!
No picture of a Sun. The number 16 degrees C on the left hand side. Thanks for the replies.
See image: http://s28.postimg.org/52nla2wcd/WP_20141005_001.jpg
The display is identical to the fig 7 on page 6 of the manual I uploaded.
Side note - I took safety precautions and removed the cap on the immersion heater and one of the cables coming from the heating element is completely burnt out. I've only just moved into the apartment within a few...
Hi,
I have a boiler in my kitchen and a water tank in the airing cupboard. My friend turned off the immersion heater via a switch on my wall 4 days ago, I have only just noticed this now as I have no central heating or hot water. I turned the heater back on yesterday and left the tank for an...