Recent content by ionlyask

You miss the point. When I experienced the same problem as the OP I read the thread some weeks ago looking for some guidance on possible solutions. The posts though appreciated did not provide this and I had to work out the answer myself. I posted what had worked for me so that others looking...

Try fitting Danfoss RA-G high flow radiator valve with either Danfoss high flow balancing valve on return connection or fit a right angle bend here to maximise flow. Worked very well for me.

Thanks for your post andrekhoury; allbeit it is a bit late to be of help to me. It may however be of help to others. The pressure loss problem got much less after my last post, but returned at the end of April 2010 when I called the manufacturer which quickly sent an engineer. The problem was...

Hi Bengass. I am pleased that you have a balanced view on the meaning of the gas regulations that is much the same as my own. To clarify what I and the commisioning engineer did. I, 1)brought the water pipes close to the boiler, 2)bolted the boiler to the wall 3) cored the...

See link below to relevant legislation on gas safety. Bear in mind also all work on the gas side was carried out by a registered Corgi engineer. However much you might want it to be otherwise nothing in the regulations requires you to be registered with CORGI or HSE to work on a...

Don't see that the installation is "illegal" under the regulations. All Gas work, connections at boiler and commissioning done by qualified engineer. I hung the boiler and carried out standard plumbing work to system pipework. I am "competent" to do this I appreciate that my/any engineer will...

Boiler type two month old Veissmann 100 W combination System is depressurising by about 0.5 bar a day. No apparent leaks in pipe work radiators etc but as usual there are areas that can’t be seen. To see if problem is fully or partly with the boiler I closed flow and return valves when...