Recent content by ipbr21054

  1. I

    Issue with tow bar electrics

    Led draw little current so the can bus system thinks a bulb is out.Usin gth etrailer board with bulbs fitted all is fine. So trailer needs bulbs as opposed led
  2. I

    Issue with tow bar electrics

    Ok Tomorrow I’m borrowing a trailer boards with lights. LED don’t use much power so thinking can bus assume bulb is out.
  3. I

    Issue with tow bar electrics

    Flash rate on my Suzuki with trailer is fine. Honda faster. My Suzuki is 2005 Honda is 2012 So I was wondering if the Honda can bus system has some affect with it. I need to try it out with a trailer board & bulbs to illuminate my led. Sound about right to you ?
  4. I

    Issue with tow bar electrics

    I'm looking to buy a HONDA CRV 2012 & have noticed that the electrical towing socket has 13 pins thus being what they call European. My current car being a Suzuki & trailer use the standard 7 pin setup. Because of this i bought a converter lead that connects the new car 13 pin to my trailer 7...
  5. I

    EICR results question

    The ECIR was done. He sent a report. Waited ages for a quote. Got another electrician to look at report quote and do it.
  6. I

    EICR results question

    I’m not an electrician so I’m asking first is there is such a tool.
  7. I

    EICR results question

    I’m not an electrician so this is why they are short.
  8. I

    EICR results question

    I have a multimeter but leads are say 1 ft
  9. I

    EICR results question

    The electrician did the test and left. I see the report & see on the quote how long apparently it’s going to take. I’m keen to look do it myself and to not lay them. Hence why I ask if there is a toll so when I plug in I know which socket it is without doing all of them. Then one less job...
  10. I

    EICR results question

    Selling property. I’ve changed some sockets over the years. Only EICR done otherwise I’m unaware of this.
  11. I

    EICR results question

    Are you saying for me to check wire size & advise as the reading might be ok & he didnt recognise it. Thanks for your time.
  12. I

    EICR results question

    not sure to be honest
  13. I

    EICR results question

    Ok i will switch off electric & check all earths. I was thinking that there was a tool that you plug in the socket & when switched on get a reading. If all sockets were lets say 0.3 & one was 0.9 etc then that socket is the one with the fault, either being check wire or just replace socket...
  14. I

    EICR results question

    Thanks. So the earth is the issue in this case. I suppose once ive done them all then there is no way i can check the reading & he will have to check when he does the other work.
  15. I

    EICR results question

    Looking at the paperwork he left under ring final circuits i see the following. I assume this is what your asking ? Thansk
See more
Back
Top