Hotpoint dishwasher number 5 flashing & cycle ends after say 10 minutes

[ipbr21054]

Ive moved into a new place & have an issue with the dishwasher which is the integrated type.
I switched in on then selected programme 4 then pressed start & closed the door.
First thing i hear is it draining.
I can then hear is filling with water.
I go about unpacking but 10 minutes later i think thats quiet.
I open the door & i see a number 5 & the on / off button is flashing.

The paperwork mentions unable to drain BUT first thing i hear is it draing & no water in bottom of machine if that's a true reason as to why its flashing so it did ddrain.
Even when i put 2 jugs of water in it drains.

I did the same again & selected other programmes but the same thing.
I removed the metal plate & i see water.
I remove the plastic cylinder filter & its clean but ran it under the tap anyway.
I also switched machine off & also off at the wall for 30 minutes to see if that might clear an error etc.

I run another cycle & grab the outlet pipe that connects to the pipework under the sink & can feel it moving etc as water is draining.

Any idea whats going on please.
The cleaning table i put in it is untouched & cups on top shelf are dry.
The place im in is 2 years old so i would think this then is also 2 years old.


Thanks

 

[CountryFan]

A quick internet search suggests a few things:

A blocked drain, hose or trap, so the water can’t drain away

A pressure sensor issue - eg broken

I would also check the inlet to the machine, make sure it can actually fill with water

 

[ipbr21054]

Hi,
If the machine has no water in it does that then mean its draining away ?

Will need to look at what the pressure sensor is.

The hose is right behind the unit so that might be hard.
If i leave it on for say 5 minutes & open the door water should be in the bottom ?

 

[CountryFan]

Hi,
If the machine has no water in it does that then mean its draining away ?

Not necessarily, it might not be filling

If i leave it on for say 5 minutes & open the door water should be in the bottom ?

Yes.

 

[ipbr21054]

OK,
Ive removed the rear wooden part & i can see the pipe.
I start a cycle & hold the pipe higher & can feel hear the water being emptied no problem.

I hear the machine hum for a while so i open the door.
Its humming but no water.
Maybe humming is no water in machine.
I did hear it filling at the start but its empty inside.

All water taps are in the on position.

Photo shows pipe in question but its at least a foot too long i would say as i was able to pull out the excess & hold it up.