Recent content by Jakzon

They are/were daisy chained and one cable back to the old panel location. I'd have to double check but pretty sure it's 6 core cable with 4 used in old setup (Eg shock alarm= red/black & tamper=blue/yellow). For double pole on the premier 24 panel, it looks like I need to use a zone for alarm...

Ok so an update, an analyser board is required for each of the old inertia sensors. At around 8 quid each it's a no go. As new impaq sensors are a tenner! I had planned to use eol on each sensor/zone but in their sitting room there are 5 small windows. According to the installation manual no...

When the cover is off, it looks like the attached picture(minus the magnetic contact). I'm getting the feeling that we will have to buy the texecom impaq sensors for each window. I thought that if magnetic door contacts were ok for the texecom then these simple sensors would work the same.. A...

They are like the attached picture. I think there are ball bearings inside that generate alarm under vibration. There is also a tamper circuit.

Hi sparkymarka, The old panel was a scopetronic/home guard. It only had 3 zones so the window shock sensors were daisy chained to fit. With the Premier elite 24 and 8xe expander , I will have 8 zones (Panel) and 8 tampers(8xe) if wiring NC? They have 2 doors and 9 windows.

Hi all, My parents house alarm of over 20 years recently packed up. So myself and my sister bought a new premier elite panel with the 8xe expander and the IP Com external box. All good so far. So I have read the installation pdf, got a copy of wintex and read all the threads here on this...