Recent content by jameslpool

Hi, we had out shower tray, enclosure and tiles replaced about a year ago due to ongoing issues with cracks in tiles and a crack in the shower tray. We got that all sorted and is fine (i am assuming this isn't from the new shower) Below as you can see on the pic, there is a patch of mould...

Hi, we had out shower tray, enclosure and tiles replaced about a year ago due to ongoing issues with cracks in tiles and a crack in the shower tray. We got that all sorted and is fine (i am assuming this isn't from the new shower) Below as you can see on the pic, there is a patch of mould...

I didn't really find anything i thought would work for that, is there anything else?

Hi, we have a walk in shower, but it's only a 1200 x 800mm tray So a bit of water sprinkle seems to still get out of the part of the entrance where the deflector panel ends. Our shower is facing the front glass and deflector, rather than facing down the shower, as it would normally be with...

Cheers, well from looking at standing height you can't even notice it, you have to be eye level really, will just leave it be. Thanks for your help.

Madrab - I have just taken another pic, the others where in shade, which i think makes it look worse, this one is with the normal light on it. Its hard to know if that black dot is just a bit of dirt that hasn't cleaned off or not. I can't get under no, its a walk in type and was glued down to...

Thanks for the replies, after giving it a clean it looks like the pic below. although when looking in person it looks mostly all white where you can see the darker bits. It looks like something pretty specific has dropped, not to sure what it is though. How think are these acrylic trays...

So after giving it a proper clean out, it actually looks white throughout with no actual crack as such, it's like it's just dented in a bit. Would i be best just actually leaving it, if its not causing any issue, or do you think i'd still be best applying something to fill it in a bit, so it...

Hi, we have an acrylic shower tray, which is fixed onto a ply bottom. I have literally just noticed a small crack in it, which I have never noticed before, as shown in the below pic. It's about 0.5cm seems like it goes a tiny bit inwards, so I'm thinking something may have dropped on it? There...

This probably sounds a strange question, and I don't know if it's just how our tray was installed that's the issue. But is it ok to leave the cover off a 90mm shower trap and leave just the bucket part in the waste, ours is like the one pictured below The reason I asked is, no matter how clean...

Dilalio, yeh i know it gets done via the plates

Hi, I am not sure if anyone can help with the below pictures? We need the toilet valve replacing for this concealed KOHLER toilet. The top can't be taken off unfortunately, well not easy anyway, sink would have to be removed etc.. It has been a challenge trying to locate the valve for it. The...

Hi, we have a wired doorbell, and have found, every time it rains heavy, it stops working. Oddly, when I look at the doorbell itself, it's not really wet, as it is fairly covered from the roof and part of the side of the porch. I am not sure where else water might be getting in to stop it...

Hi, I know these lights are solar and now electric, but wasn't sure which other better section to post it in. They have a dome shaped sensor, which has no settings as such, I want to stop certain sections from working, as the light at the side of the house, but still picks up people walking up...

Hi, my daughter pulled the tap handle up, which I believe to be our Vado Photon mixer tap. Does anyone know if you can replace the handle, does it just push on, or would it have been fixed on? Part of the housing on the handle is snapped, I think if i gled it back on, it wouldn't just keep...