Recent content by jamiedgwilson

I have a Shower cord pull in my en-suite that has power to it but doesn’t go on to a shower as a mixer was fitted instead. Would it be possible to swap the pull switch simply for a shaver socket? It’s run in heavy twin and earth (I’m assuming 10mm but haven’t checked yet) so over rated for a...

Hi all, sorry for a bit of a stupid question - I think I know the answer to this! My house is around 10 years old (I've only lived there a couple of years). The windows have no external silicone around them. The rendering just goes straight up to the windows. I've not had any problems with...

I have a Bristan Bliss electric shower. It doesn't have physical push buttons but rather 'touch' buttons. I can run it no problem and it holds temperature perfectly. However, when taking a shower it can sometimes switch modes and jump to 'cold'. I can instantly switch it back to 'hot' and it...

Thanks for the reply. I have another 2 channel receiver that I am using for downstairs heating and hot water and this one is just for my upstairs heating. I'm fortunate enough that the wiring junction is in a cupboard directly behind the upstairs thermostat so easy to take the wires back to...

I'm installing a Hive 2 controller and would like some advice please on removing my old room thermostat. It is currently in my upstairs hallway and I'm replacing it with a Hive multi-zone stat. The current stat has 3 wires as per the attached diagram. I was planning on bridging out 1 and 4 but...