Recent content by Jango_Fett

I've checked the polypipe cold feed section in the attic with a clothes hanger and its not blocked...my guess is its frozen somewhere at the top of the wall or around the eaves which is a beatch to get at...

I've just noticed this morning that my tank in the attic was empty. Ball cock working ok, cold water to kitchen sink ok. I've disconnected the pipe going into the tank in attic and disconnected it at the next fitting 6 foot down pipe and its clear....water flowing through it. So I...

thanks

I managed to get my hands on a new stabiliser valve/solenoid assembly and replaced them this morning so its back working now, thanks. I'm going to keep the old assembly, but thinking about getting a solenoid separately and just replacing that, thing is it doesn't seem to come off. I'm able...

any idea of cost for one?

Thanks for that... I just ohmed out the solenoid terminals with the power off and it was open circuit. Is it the solenoid then?

The shower will run for a few min and then just stop flowing water. Low Pressure light comes on. Seems to happen more in the morning than in the evening. I ran it for about 5 min last night with no problems but the last 2 mornings I have been caught out with it cutting out mid shower...

nope.....just an enclosure with a gas detector in it

I currently have to install 2 heaters. One heater outside an enclosure which is self heat regulated and one inside the enclosure which will be controlled by a thermostat. The external heater has a running current of 1A. The internal heater has a running current of 0.5A, but has a switch...