Recent content by jasonp

Thankyou for all your suggestions this is a very good site.Just thought i,d give you an update might be helpful to others.I have managed to sort out the problem,it turned out to be the ch flow valve under the boiler on the left.I isolated the boiler and removed the filter from the valve it was...

The temp sensor has tripped a couple of times but after a reset the problem still persists.I have also found that with the boiler set to dhw only,when i run the hot tap the radiators are getting warm.If the diverter valve was sticking would the bar pressure also be high? any advice would be...

Thankyou for the advise is that why the boiler is making a straining noise.The water is finding its way down the ch flow as the pipe below the boiler is getting hot but like i say it only runs for a few seconds before shutting down did i also mention that the temp sensor trps out quite regularly...

Thankyou for the quick response the ev pressure is set to 1bar at the minute and holding but no improvement should i monitor the ev pressure over time and if it,s losing pressure what would i expect to pay for an engineer to replace it in the leicester area?

Hi i have a baxi eco 80 combi boiler.dhw works fine but when i call for ch the boiler fires up but then the burner cuts out after 10 secs.The bar pressure also goes above 3 bar.I have repressurised the expansion vessel as it was full of water but the problem still remains,Also just before the...