Is there an option to just switch heating off or do you mean switch boiler off?
When boilers off no hot water, when i turn the heating right down to minimum and try water, it only runs hot for a minute or so then gas cuts out and shuts boiler off.
Ok makes sense.
Circuit board needing replaced again then. Just to confirm before i order it, heating and hot water stops working when the boiler cuts out (flame in tell-tale window goes out) in your experience this will be a pcb fault?
No sorry, my boilers expansion vessel is flooded, it kept dropping pressure so the engineer suggested flooding it to stop this rather than replacing it as apparently its a nightmare to replace on my boiler?
I keep the pressure just under 1 bar, the prv has a very slight leak so will drop slightly over the course of the day but i always make sure the pressure is just under 1.
Would i be aswell getting a new pcb then?
My boiler (worcester 28i rsf) doesnt produce hot water at a constant rate.
Runs hot then goes stone cold. Ive noticed that the pilot cuts out at same time so unsure of what is causing it.
Heating seems to be working fine although it would be hard to tell if the heating cuts out also as it...
Thanks for replies decided to keep the original doors and try fix them up.
Question though, the doors were boarded over, after i removed the boards there has been an awful smell coming from the wood, even after painting.
Any ideas in how to get rid of the smell?
Im wanting to replace the doors in my house but they are a weird size.
Living room is 2095mm x 855mm
Bedroom is 2110mm x 840mm
Bathroom is 2090mm x 600mm
Anywhere i can buy these sizes off the shelf?
Yeah il get one ordered, soaked it in hot soapy water and tried cleaning it best i can, a lot of black crud removed.
Seems to be holding now for the time being, but il just replace it for all it is.