Recent content by jaymin

yep, looks like old back boiler

take it up start a fresh, only way to do it properly

lot of work for nothing,

look at the loft to see where or if its supporting, thats first step

wrong waste... get a mcAlpine bath trap

jet wash turn it down to min pressure and build it up, leave bath tap open to flush it out

i have done these normally floor fitted then services are run around the edge and a small box wall is built. In a loft these always a cover wall as normally you have storage in the eves

2mm spacers , then you know you joints are good.

ardex p51 or ctd ultra trade is sbr in there pot.. cheaper

2mm, perfect

i use 2mm pegs and rubi level system on 600x300 and over, tiles are not as good these days, kerakoll is good bit runny for me , i like ardex

yep its good, i like ardex

8mm towel run it tight, always primer the plaster stop it drying out uneven. if your use a bench type cutter go continuous blade and lots of water , i use rubi or marcrist

hi, i have just brought my first steel frame house built in 1951. i understand the no cavity fill rules. so I'm thinking of building 50mm false walls on the inside filled with celotex to make a warm wall system... anyone done this ? thoughts ? thanks jason