Recent content by Jeramy

hi, there is PRV installed

Hi the gauge is attached to an outside tap. I suppose i will just reduce the pressure in the accumulator to just below that of the mains?

I cant see how the accumulator can fill up with water if the ballon pressure is greater than the mains pressure with out a pump being involved?

Hi, With 2 showers on the pressure drops to 1.8 bar. There are four showers in the house but only 2 would likely be used simultaneously.

Hi thanks for the reply. What i would like is for the water pressure not to drop when more than one shower is being used. When i put a gauge on a tap i get just under 2bar. I have an electric car tyre pump which i can use to change the pressure.

Hi, I have a massive 310 litre expansion vessel connected to a glowworm 300 litre unvented hotwater tank which i think is there to maintain pressure when 2 or more showers are being use simultaneously. Can anyone tell me what the pressure should be in the expansion vessel. I have a water...

HI GalxyGuy, sorry for the delay in getting back to you. Option 53 "1001 bells L POS" "1002 strobe L POS". I hope thats what you meant? Thanks

Hi, when my galaxy flex 100 alarm throws up a fault (tamper, supervision, battery etc) i get a beep from the number pad, internal sounder and annoyingly, especially for the street, the siren box. It has only done this since i have flashed the firmware to latest version. So i'm hoping its just a...

Hi sorted it [51 47]

Galaxy flex 100. everything worked well before i flashed the firmware. So its just a setting i need to access on the keypad to get it back to how it was before.

Every time i set the alarm the Bell box and sounder beep twice (not good for the neighbours) if i do part silent no noise. any ideas anyone

Do you have a final door zone and if yes whats the pir facing set to?

Will i get false alarms if the final door zone and the hall zone become open at the same time?

yes you are certainly right its ambiguous

Hi, I have a magnet on the door zone1 set to final. Should the pir in the hall, zone2, overlooking the the door and keypad be set set to Exit or Entry? Thanks in advance. Jeramy