Thanks for your kind help.
I can lift the metal inner drum about half inch! and the outer doesnt move.
and that would indicate the noise then from the clanking sounds.
What does this mean? I thought there should be a little slack .
Thanks
My mother erported a very loud banging noise from the washer like the comparison of a large house brick could have been in there. I took the lid off and ckecked inside but all is tight and seems ok. She then attempted to do another wash later and said nothing was happening at all... no water...
Cheers for that ma man. removed the motar and a big chunk of carbon fell from it, must have snapped off from the old brushes i guess.
Still cant understand how this could cause a trip like? but anyway
Job sorted - mums happy
She works a treat, well does now after 3 hours ****ing about...
Cheers pal -
Take it thats a job to remove the motar totally. I got away with just putting the brushes in without removal and thought i was good lol.
Yer will try this, need to look into removal as i can only get to the first bolt.
Do i have to lay flat and get the other from the bottom...
Hotpoint firstedition 8000
Mother reported a problem of burning last week and that the washer wasnt spinning anymore. Looked into this and the Brushes had worn right down. Replaced them both with genuine carbon brushes. Fired it up and worked a treat during the wash cycle but as soon as it...
Hi thanks for replying,
Will have to check on the water tank in loft. It's not my house. Wonder What kind of system is installed here. Looks like a Combi boiler, same settings with a pressure filling loop etc but can't understand the need to install a new water cyclinder right next to it...
A few months back now I had problems with a bath mixershower.
Anyway the problem was that the water was either too hot or too cold. You could try for ten minutes fiddling to get the temperature right but it wouldn't happen - the shower would either produce redhot or freezing cold. Anyway i...
Hi,
I've had my double glazed windows in for about 4 years now. The guys who fitted them cam out last year and the previous year to adjust them.
I don't know what they did to the windows but they tightened them on closing. This reduced noise and draft. Anyway now it's getting cold an...
Ok the problem was with the Lockshield valve - I uses an ajustable spanner to turn this fully left, it was really tight and i thought it was going to break (must not have turned this hard enough yesterday).
Anyway it moved about a quarter of a turn - fully left. Immediately the pipe...