Hi Everyone,
I am in need of some assistance and the following scenario needs to be addressed;
I need to set up a wireless cctv system for a minimum of 8 camera's. The building is a house converted in to a dental surgery.
Concerns;
Interference? what is the quality I should be...
Hi there,
I use this company www.elizajames.co.uk
They know what they are doing and to the trade support is also good I used to deal with the mainstream guy until I was recommended Eliza James by a trader.
Thanks,
JR.
Hi,
I beleive they have a problem with the landline.
try again on 0208 531 5660
They are based in waltham forest. not fat from the Costco on the A406.
Regards,
JR
Hi,
Is it a laminate finish or a lacquered finish???
Would it not be simpler to buy a door that size there are avarious companies on line that do that sort of stuff
you could also try one that I use and recommend;
www.elizajames.co.uk
Regards,
JR
Hello There,
You could try this company;
www.elizajames.co.uk
I am more than certain they will be able to provide you with the cornice you require and possibly able to match the existing cabinets too.
Alternatively contact UWP on 01708 726 736.
Hope this helps.
JR.
Hi there,
I use a company called Eliza James and they should be able to help you with your requirements.
www.elizajames.co.uk
Hope this helps.
Regards,
JR[/url]
Hi,
Contact these guys too;
www.elizajames.co.uk
I they do also sorts of stuff besides their mainstream products, I have used them to manufacture various bespoke funiture and other items.
Good luck with you quest. :)
Regards,
JR
Hi there,
If you plan to continue fitting worktops then your best bet for a good looking finish would be to get a router and a jig.
Should be able to pick one of these up from Screwfix.
If not, then you can get someone in to do it for you at approx £120.
If neither of these are an...
Which CNC/Press are you using?
I already responded on another post to you on this subject. Use a moisture resitant MDF board or a high Density MDF board. This will help resolve the problems you describe.
Regards,
JR
You need a better quality MDF for that process. Try a high density MDF board or moisture resistant MDF board. You will still require some light sanding down after the CNC process but it will be a much better finish.
Regards,
JR
Hello Damo,
You will require 1 door to cover the shelf unit 2382mm (h) x 419mm (w) assuming the width in the image is correctly stating 396mm as the internal measurement.
Middle door will be 2382mm (h) x 405mm (w)
Door on right will be 2382mm (h) x 414mm (w)
And you will not really...