Can you describe the surface beneath where the plaster has fallen off?
If it is very friable or dry it may be the reason the patch has fallen off in the first place. E.g. Inadequate prep was made in the first place.
If it is very dry, and has a high level of suction the job can be a bit more...
Has anyone ever user masonry paint to control suction?
I’ve got a room where areas need building up (12-24mm thickness varying) with a backing coat on brick before skimming the whole room , but the brickwork is as dry as sticks, and thirsty as hell.
That ‘Artex Stabilex’ is tricky to get hold...
In my experience, you can feel the join in the cheaper non-branded belts when you're sanding - which tends to make the belt sander 'jump' a bit. I haven't had this problem with the bosch belts i've used in the past.
In my experience, you can feel the join in the cheaper non-branded belts when you're sanding - which tends to make the belt sander 'jump' a bit. I haven't had this problem with the bosch belts i've used in the past.
I think what can happen when the Expansion Vessel fails is:
The rubber membrane in the EV perishes/disintegrates over time. This leads to a loss in pressure in the system, perhaps because the air contain by the once intact memebrane escapes through the auto-bleed valve, or perhaps ends up in...
so what is the part number of the main board for the older model, i.e. the one like mine which has a blue ignition box on the gas valve and no seperate ignition module (10021848, replaced by 10028891).
Is is the same for all versions?
Thanks.
is there an earlier version of the linea 24 than the one in the MI from the vokera website?
i went to replace the ignition pcb and its not there!!
is it integral to the main board?