Recent content by jonnyfonny

Than you for your reply. I appreciate I may not get an all singing all dancing model with my 13 amp restriction. Just a fan assisted oven that gets up to temperature and cooks evenly would be a start. My current Whirlpool is hopeless, and never gets hot enough. I'm just looking for...

Hi everyone, I'm looking to replace my single integrated oven which is a Whirlpool (not sure on model - currently at work), with something of better quality that does not require hardwiring in by an electrician, i.e. it comes with (or at least accepts) a 13 amp plug. I've been looking at...

Well after a lot of emails backwards and forwards I eventually received this reply: Hello There is an 18 month warranty on our products when bought through our merchants. We regret that we are unable to provide assistance to you on this occasion as the goods were purchased through an...

Thanks for that. I've emailed them so fingers crossed! I've asked them if they'll do a swap for a small fee (with it being out of warranty). Hope the weather warms up. Don't fancy being cold if I have to remove my unit before I get a new one! Cheers again Jon.

Hi everyone, I have a honeywell CM927 married up to a BDR91 receiver. The thing is, my BDR91 receiver is faulty and I require a replacement. It only has a range of 6 feet of so. I know it's faulty as I have swapped it out with another one which works fine. Does anyone know if it is...

Thanks for the tip on the rechargeable batteries. Funnily enough we did swap out the originals for rechargeables (just to test) and it did seem a little worse. I've tried rebinding on numerous occasions but to no avail. I've attached the diagram from my parents boiler. [/img] Now...

I did buy the set new. Unfortunately it was over a year ago (and from ebay). I've just taken my thermostat round from my house to eliminate it as a suspect! I paired it up (binded it) and did the range test again. It was no improvement whatsoever. I'm beginning to think it is either: A...

OK. Just to update. I've put new batteries into the stat and moved the relay into the roof of the boiler house. Again the signal dropped out in the kitchen when I moved the thermostat to about 10ft from the wall the boiler mounts onto. I also tested the range outside. So with nothing...

The main reason for not locating the relay where the old stat was 2-fold. Firstly, when I looked at the old stat it appeared to have a collection of black wires, and nothing seemed logical. Secondly, when I checked the wiring into the boiler it appeared that only one device was wired in...

Ok, I finally got round to fitting this thing over the weekend and it was pretty straightforward (thanks to all the help on here!). I do have a problem with the wireless range though. :( I'm going to try and move the relay box right to the top of the boiler house as far away from the boiler...

That info is very helpful thank you. I hope to tackle it one morning this week, so be prepared for more questions if I get stuck! :) Cheers guys. This forum is awesome!

Thank you for your replies. I've just been in touch with my dad and the boiler is a worcester-bosch i-series boiler (the 24i). Unfortunately he says the last heating engineer he had in disappeared with the boiler manual. So, could one of you more knowledgable ones help me to determine...

Thank you for your reply. I'm hoping to have a look at it this weekend if I get chance. I really hope that it is just a case of replacing the thermostat in the bedroom with the relay box (with a bit of modified wiring, like you say). I rang a couple of local electricians but they wanted...