Hi
We looking at adding an extra extractor fan to our bathroom but unsure if we can go through the flat roof or through the soffit?
The flat roof would be easier as would not need to cut the joists etc and go directly above.
But the flat roof is not made of felt its a white plastic...
Hi
We looking at adding an extra extractor fan to our bathroom but unsure if we can go through the flat roof or through the soffit?
The flat roof would be easier as would not need to cut the joists etc and go directly above.
But the flat roof is not made of felt its a white plastic...
Hi everyone,
Just got a sideboard and it needs a little refresh, and there is one spot which looks like has gone back to wood, or faded a little too much.
Its solid oak so what is the best way to restore this, aslong as it looks the same all over i'll be happy
Pics are below...
Hi guys we have to normal size rooms 3.5x3.5 (x2) that have artex on them, we would like flat celings.
So would it be better to skim them, or platerboard them skim them?
We have very high celings so can get away with losing 1" or so.
Any advice would be great
Hi guys,
Need to run a couple of pipes in studwork.
Do you do the holes as tight as possible or a little loose?
So would 16mm drill bit be ok?
And when you get to the elbow joint do you also support this
Thanks, any help would be great
Hi everyone
Bought some butt connectors (blue and red) and a ratchet
http://www.screwfix.com/p/ratchet-crimping-tool-1-5-10mm/49092
but can never get a good connection and sometime you see a bit of the bare wire being pushed through
Is it the ratchet or am i doing things wrong
Thanks
Yes i have
As stated i wanted to add a further light down the hall so i needed to move the wiring as the same in the landing i.e
Was this-
Landing
L1: Red + brown (line)
L2: Black + Black (switched line)
Com: Grey
Earth - connected to back of box
Hallway (2 way switch)...
Hi can i just run something past someone
Installed the wires and both light work and both switches work. But is this correct
Landing -
L1: Red + brown (line)
L2: Black + Black (switched line)
Com: Grey
Earth - connected to back of box
Hallway (2 way switch)
Red - L1 (first...
Hi
Sorry for not being clear
Landing switch (1 gang) - Just turn landing light on and off
Hall (a) 2 gang - Turn landing light on/off and hall light on/off
Hall (b) 1 gang - turn hall light on off
Hi everyone
New 3 core has been run
I would like to keep the existing switch where it is now
But also add a single switch a few meters forward of the 2 way there now.
So be set up as follows
Landing (1 gang) - Hall (A) (2 gang) - Hall (b)
Do you just mirror like someone...
Thanks
Have now managed to get the cable back to the landing switch just a few holes in the wall now
Got the cable coming tomorrow so will get it all sorted tomorrow.
And
Regarding JB
Should i crimp cable using butt ends and then put them in a chocblock?