Recent content by josip

  1. J

    Wall hung toilet not tight against wall

    Yes, that's how far it sits out from the wall without the packing. According to the plumber the packing at the bottom is to prevent possible cracking up above at the mount points later on if the bottom sits out from the wall. The tiles are at most 3mm off plumb along a 60cm spirit level. So I'd...
  2. J

    Wall hung toilet not tight against wall

    The leak was because he pulled too much of the flexi connector waste pipe to make his life easier connecting to the toilet. It disconnected from the outside down waste pipe and was flowing down inside the cavity block. Thankfully it was all clean water at this stage. I've checked the toilet...
  3. J

    Wall hung toilet not tight against wall

    We're getting a wall hung toilet installed. Went with a Toto rimless and a Geberit Sigma Slim Frame https://www.idealbathrooms.com/products/toilets/installation-frames/111799003-36449 After the plumber installed it, the bottom of the toilet sits 16-17mm out from the wall behind and said we'll...
  4. J

    Under tile insulation

    We're insulating an existing house before we move in. The only weak spot left is the kitchen tiles on the concrete floor and I had thought to put tilebacker boards under them, the type that are used under electrical underfloor heating systems. I've been quoted 53 Euro/sqm inc VAT however for a...
Back
Top