Recent content by kampc

I assume you meant the user code not engineers code. Only lights on panels are the top one - wavy line next to it and the other at the very bottom with a padlock next to it. If I put in my code the second light from the top flashes red and the internal alarm starts to sound

Sorry not been on for a while due to a bereavement. Battery replaced but i still cant seem to reprogramme. Think I need an idiots guide!! After I finished reprogramming , four out of 5 of the pir detectors lights have now gone out!!! When I set the alarm, after 45 seconds the internal alarm...

Its a 9448 style alarm with a 9427 style keypad. Do I remove the key pad/9427 cover to check this as cant find anything on inside 9448??.

I thought if I did a reset it would default to factory settings and would work fine. Do I just follow the Engineers programme command list, I have tried doing this but when I finished and tried the alarm, the internal alarm sounds continuously after I have exited the property for some reason and...

Thought that if it was hard wired regardless of a faulty battery, it would still work. Thanks for the advice, have ordered a new battery and hopefully this will work

Hi we are assuming it was a power failure as the alarm went off in the middle of the night for no reason. The key pad was unreponsive so we had to turn the power off at the mains to silence it. Did the factory reset but unfortunately we do not have a list of previous default settings just those...

I have a scantronic 9448 alarm. Power went off one night and alarm would not switch off, key pad unreponsive. Carried out factory reset and although I have manual cant seem to reproramme it properly., basically dont know what I am doing. I live in a bungalow and have 5 pir detectors, one in...