Recent content by KBarbs

I completely forgot to reply to this... I know re-opening an old thread. BUT it worked a treat. The reset suggested by Leccy758 did not fix it outright, but presented with a different error code which allowed me to do a software reset as follows: "open the door, switch it off, switch...

A bit more digging and I found this: E7 – Flow meter failure This alarm is generated when the pcb timer card does not detect any signal coming from the flow meter. This defect can be caused by, but not only, a defective flow meter which is sometimes referred to as the turbine. Based on...

Thanks for that. The code is reported as E7 - "Anomaly on the flow meter (only on the flow meter).". Do you have any ideas what that means?

Hi all, new here and hoping someone can help me. I have a SMEG Dishwasher DWI 710 E1 and there is a problem. It starts OK and then about 5 mins into the cycle (after what appears to be the initial rinse cycle) it stops. The lights on the panel are as follows: 1-3 flashing 4 off 5 on...