Recent content by kenny101

Yea i know that thermostats safety has improved greatly, but how many households have unsuspecting faulty therostats fitted from years gone by. All im saying is with hot water discharge on to roof seems to me to be an added safety measure and a far better option than into cws tank if at possible.

Is it the norm to have the domestic hot water expansion pipe to loop over a cold storage tank that plumping hot water discharges into,if the case there are many accidents waiting to happen as recently seen in tragic case of cws bursting. In my own house and many more they have the expansion...

Thanks guys, reading the thread a few before mine simliar advice given there, much appreciated

Hi guys, i am hoping to relay a new patio using riven paving (precast type from diy shed) At present i have 2x2 old grey pavers which are layed on good solid base of quarry dust well compacted over the years. The new pavers are a about 1inch thinner, can i use a morter on top of the old...

cheers guys thanks for reply. i know towel rails give crap heat but her indoors just loves chrome. ( TOWEL RAILS )

would it be o.k to connect a towel rail to 15mm pipes feeding an existing small radiator in bathroom or would this take a lot of heat from radiator.

Try a flexible pan connector, these have as much as 4 to 5 inches of flex in any direction.

flexi hose 15mm compression both ends.

10mm rad valve.

I,d use flexible tap connectors,remove the copper tails and fit directly to threaded tap tail and a compression joint on other end of flexi connector or a push fit speedfit,but don,t forget about inserts when connecting to plastic pipe. :)

Thanks all for for your comments and deciphering my very poor description of topic,went into honeywell web as advised and got info.Has to be the best forum by far. :) :)

If installing a 2 way zone valve for CH & HW would this have to be fitted on the 22mm return before the first rad and a 22mm branch before the zone valve going to the HW cylinder or does a 3 way valve do the same job without having to put in a 22mm branch pipe.Hope someone out there can make...

Thanks GASMAN balanced system by closing return valves down a little on other rads hope it all works out, days ahead will soon tell. Info much appreciated. :)

Need some info on adding a rad in loft conversion. It is an oil fired open vent pumped system in a two story house. Would i need to raise f & e tank, need a more powerful pump to circulate water higher any info would be appreciated. :? :?

Thanks for the suggestion, will try & keep you posted of any success.