kingandy2nd's latest activity

  • kingandy2nd
    kingandy2nd replied to the thread Workshop Mk2.
    Some renders say you can prime cracks and paint but I think you should probably give EWI a call and see what they say. Good luck :)
  • kingandy2nd
    kingandy2nd reacted to i_am_fubar's post in the thread Workshop Mk2 with Thanks Thanks.
    Blocks Primer EPS-220 EPS EPS-220 with mesh (this is where cracks are) To be done Primer Silicone thin coat render
  • kingandy2nd
    kingandy2nd replied to the thread Workshop Mk2.
    What product are you using for the render? I assume you gave the blocks a good soaking before you put the render on. My topcoat...
  • kingandy2nd
    kingandy2nd reacted to i_am_fubar's post in the thread Workshop Mk2 with Thanks Thanks.
    It begins. It looks flat, but far from smooth. Going to leave it an hour and sponge it. I think the mix had too much water and it was...
  • kingandy2nd
    kingandy2nd replied to the thread Workshop Mk2.
    I was going to say if it was the floor it’s not big enough to worry about.
  • kingandy2nd
    kingandy2nd reacted to i_am_fubar's post in the thread Workshop Mk2 with Thanks Thanks.
    Yup, it's very minor and doesn't span the slab width. About in the middle too, between the piers. I'm assuming it's the walls pressing...
  • kingandy2nd
    kingandy2nd replied to the thread Workshop Mk2.
    Is that the floor?
  • kingandy2nd
    kingandy2nd reacted to i_am_fubar's post in the thread Workshop Mk2 with Thanks Thanks.
    Let there be light! I'm a big fan of this ;) It's all wired back to a single flex on an IEC plug And the ring is in. It's been a...
Show older items
Back
Top