Recent content by konnie8496

i was hoping not to hear that but i did suspect it could be that,,,can you tell me ,how should these thermistors read on a multi meter,,just to be sure before i purchase a new pcb and i appreciate your valuable knowledge

no i tried another one from from a similar machine,,

hi again i tried bypassing the thermistor but it still has the same fault do you know if there is anything else i can try to rectify this problem ? thanx

i take it the thermistor should read closed circuit on meter if working ok..?

will do ,,is there any other checks you can suggest i should try to any other parts if it isn't the thermistor at fault,,?

thanks i will give it a try ,,,is there any other checks i can make as i wont be able to get back online from her house so any other checks you can suggest would be much appreciated

i would be gratefull for any more possible causes to try if the thermistor wires dont do the trick

thanks for your reply,,i will do it tomorrow as its my sisters machine ,,and i will let you know the outcome as soon as i have done it many thanks

yes it fills and the inner drum turns to wash cycle although i haven't tried it on a spin cycle it wont go past the first wash cycle because the water does not pump out,the pump starts for about 2 to 3 seconds and it shuts down and goes to pause mode

hi thanks for your quick response ,,it is a washer dryer and the model number may be WLD540 OR ITS WD540 the number is slightly scuffed when i put it on an empty cycle the pump starts to empty the water but stops after a couple of seconds and the machine goes onto pause

hi my wd540 washer dryer pump starts to empty and shuts down after a couple of seconds does anyone have any idea whats causing this thanks