Recent content by kysauk

Thanks Jasonb :D

I've gone into Topps Tiles (unfortunately, the only place in my area that sells Bal products) twice and thus far the staff have been a nightmare. The first time I went in to get a bag of Bal's Rapidset Flexiable. Bal's website says when using WP1 to skim coat the wall with flexible cement...

timbo04 From what I undersand from noseall and Jasonb you'll need to use wall plugs and screw. Not sure which type of screws, but would assume it would be the aquapanel screws which are 40mm. I believe these have a special type of coating to perhaps prevent rust etc when wet. Should be able...

Thanks for all the info! One minor point, regarding the 13amp and 3amp fcu. Isn't the difference just the fuse? The heater will be removed. I'm not sure if its off a spur, haven't opened the fcu yet.

Thanks gcol. The square notched ok for the shower coverage too then? Yes, I will be tanking the shower. Also using AP on one of the walls, because I'm moving the shower mixer and pipes to behind the wall vs on top of the tiles. I'm removing as much of the paint as possible, but some parts...

joe-90, I appreciate everyone's help including yours, however that comment was unproductive. Considering you've got 3 times as many posts in ~18 months you wouldnt expect people to critisice your "field" experience based on that.

I'm getting ready to update my bathroom and currently there is an FCU that a wall mounted heater is connected to. This is located about 1meter from the sink and 1 meter higher then the sink (about 1 foot from the ceiling) and is approx 1 meter from the shower. My bathroom is 1.8m x 1.5m (very...

I'm about to start tiling my bathroom walls. Parts of the bathroom currently has wallpaper and as I was removing it today, I found under it some kind of gloss paint and parts of the paint was coming off with the wallpaper. Can I go ahead and tile over this with just tile adhesive, or do I need...

Thanks wonderb0y, Moz, Noseall, Jasonb :) everyone's advise is greatly appricated. I start my project this weekend and hopefully all will go well. Many Thanks

I will do that...... Many Thanks for all your advise!

I went to Topps Tile today looking for the WP1... wow @ £70 I asked about the skimming the AP before applying the WP1. I couldn't remember which Bal product I was suppose to mix with the flexible concrete tile adhesive and I was told that the WP1 goes straight onto the AP and that skimming is...

Hi Noseall The reason I decided to go with the battens is so I could run the shower pipes behind the wall without having to chisel into the brick work or to chisel all the plaster work thats currently on the brick. There is about 2.5cm thickness of plaster on the brick. I was hoping to just...

Ahhh... many thanks JasonB. It's clear now :D Would you still dab and dot on the back of the AP to the baton with flexi tile adhesive? and with the batons being wood, would I need specific adhesive for wood or would any flexi adhesive work? When I did my floor tiling I used specific...

So I shouldn't use batons then? or are you meaning that I must drill the aqualpanel to the brick only and not the plaster/brick if I don't use batons? Sorry don't mean to sound daft, just want to clarify. Many thanks!

hmmm... after having another look at my shower situation, I'm beginning to think I maybe better off with the batons. Currently my shower pipes are ontop of the tiles and I would rather these behind the wall. I was going to chisel out the old plaster and into the brick to place the shower pipes...