Recent content by Larry499d

I have an Ideal condenser boiler which as of this morning shows no signs of life. There is definately power getting to the boiler through to the on/off switch, but the electronic display panel is blank (there is supposed to be a "0" displayed). I'm guessing it is the circuit board. I plan to...

I woke up this morning to no central heating or hot water. The digital panel on the boiler is blank and the digital panel on the timer is blank. It looks as though there is no electricity getting through to either of these. Is there normally a single electricity feed to the boiler which then...

The hob was installed by a relative. When we looked at the connections, there was an L1, L2 and L3 and all seemed to be connected together underneath. We connected the live wire to L1 assuming that this would make all three points live. I'm guessing that this is not the case, and we need to link...

My electric immersion heater is timed to come on 2 times a day. The timer has a circular clock dial with an inner ring (on) and outer ring (off) into which you insert small pins to indicate when you want the water to come on and go off. There is also a small light on the top left hand side which...

I am having a new built in oven delivered (about 2100kw) and want to prepare appropriate connections for it to be installed. I understand that it comes with a plug on the end of its cable - can this be plugged in to the switched socket that is part of the main cooker control panel, if it has a...

I have had a hob installed that has been connected to the 6mm cable fed from the main cooker control panel. The 2 large hob plates switch on fine and get hot, but the 2 smaller plates do not appear to work, even though the light comes on when you switch either of them on. Any ideas - is it a...