Recent content by Lickdan

Well I dont know then. I chopped all connections and put wagos on. Remained blue but didn’t seem right as the blue was slightly flashy. Went to bed and work next day and ever since it has been back to normal lol. Maybe you have a bad connection in top behind the metal plate at the top worth redoing

This is now working like this 2 days how it should but how is the question

No mate this is weird as anything. So the button is white let’s just say for argument sake it is a white overlay etched into the glass. So I went to look at it in his garage and it was white. I came home I installed it in the pitch black and it was white. Always white never seen it blue. Press...

It was blue all the time for 2 days Cut power tried reset no good chopped all butt connectors and tested output of psu 12vdc solid put it all back together Sunday night ****ed off still the same Home from work yesterday and now it’s not lit just see the white button and still working can’t...

So I come home tonight now it is not lit and white not blue what the hell

You are correct and definitely never shone blue until a couple of nights ago was always white I have looked at the wiring diagram and it looks like it is leds built into the switch board so can’t even disconnect them, thing is when I went to buy It it was white, also it has been white for 4...

Does anyone know more than me about this please. Bought this 300 pound cabinet second hand for a 100 pounds. It’s a Victorian plumbing cabinet. Now it’s been up about 4/5 weeks and the power light has always been white. Now I get up in night come into the bathroom and it’s now changed to blue...

Fitted an extractor fan in may this year and only just painted the bathroom have just noticed some streaking down bottom of wall in centre of fan so think the tube I fitted must be not falling adequately. Need to have a look but wondering if I could lag internally with self adhesive neoprene...

Hello 7 year warranty on viesmann 050 due to run out next July. Had about 3/4 issues which have been fixed but it broke down in may for a blocked heat exchanger where the engineer came out fitted a new one and said it requires a power flush as was form to debris in the system and if I came out...

Undo the pump flap at back one screw check the float switch isn’t activating and that it is actually pumping all water to tray funny how it worked first go but not second.

I thought originally the program finished but now shows pause icon ? You changed ntc below the lint filter ? Not the one in your picture

Also are you saying the fault has changed now since fitting the sensor ?

Have you swapped the sensor for the correct one as there a couple of different sensors on the machine that look the same have you tried the cycle again that worked originally?

Normally 2 on them, front one below lint filter or near the fan, I changed that one once as drying cycle was ending after 5 mins then tested it and it fixed it; so I would do that one first, the other is in base and can be hard to get to.they can be metered out for resistance and measured...

Check the reservoir if full it’s your pump 9 X out of 10 that was the fix