has anyone fitted one of these yet? are they any good or just something else to give us a headache in time to come?
been asked to fit one but would like some feed back before I commit myself
tia
the 75mm trap seal is to counter act the effect of self or induced trap seal loss.
but with a shower or bath there is residual water droplets that slowly work their way down the plug hole refilling the trap if the sael was to be lost...
the 10 programme position is normally
used when the hot water is on a gravity system. In this
case it is not possible to have CH without HW
The 16 programme position is normally used on a fully
pumped system using 2 or 3 port valves, thus allowing
independent control of HW and CH.
if...
its indicating a fault either with the overheat stat, or with the boiler.
possible causes:- faulty sensor, worn pump, restricted water ways.
you should get a Gas Safe Registered engineer to look at it.....
have you googled the cylinder to find installation manual?
if its an unvented cylinder the expansion bubble or expansion vestle has lost its charge, the manual would give you the details to recharge this.