Recent content by LordBucketHead

I've marked on the wall in pencil where the slots are on the new extractor (shown with red arrows) - but there is no plaster where I should be drawing the position of the top right hand side slot. Sorry I could have worded it better I s'pose. I'll order some Toupret Rock solid filler & PVA as...

Thanks for the replies. Much appreciated. @Wayners - cheers - looks like I'm going shopping @accelerator - pic below showing slots - there's no plaster for the top right slot @jj4091 - I'll get Henry on the job

I've removed an old extractor fan (to replace it) and lumps of plaster fell on the floor. I'd like to firm the hole up where the wall plugs are and was thinking about using foam. I thought it best to ask for advice before I do anything and I'm open to better suggestions. Thanks for reading !

aye.. I served my time at the National Coal Board and it was all gallons per minute, pounds per square inch, British Standard Pipe, British Standard Whitworth, yards, feet and inches, Hg pressure and so on and so forth and then on top of that, 30 years working for American engineers. I need to...

The bathroom has 20 y/o cork tiles 'welded' to 18mm t & g Weyroc chipboard and the boards are 'nailed' to the joists with some gun-nails. Understandably, it creaks and croaks. I'm currently ripping it out. My local DIY cuts plywood to size but it doesn't sell t&g. Does it matter if it's t&g ...