Yes thats what I initially thought, but then I actually wondered if underneath it needs to be a full plank, could just be several short planks. Does not need to span the whole underneath I mean.
Not sure if this is the right forum for this...
I have this lean to roof that is polycarbonate sheets. But its leaking in the top right corner, the corner away from the front that I could reach on a ladder. The corner that has no sides for me to reach via a ladder. Its enclosed by walls. See...
I cut a hole in the attic floor to access it and it wasn't blocked.
So I checked the outside drain... The people who did my drive recently concreted over the drain outside and put the cover on top! So I had no idea until I took the cover off. The concrete had collapsed in, blocked the drain and...
I think the soil pipe is blocked because all the bathroom drains are all slow and flushing the toilet makes water spurt up into the bath from the drain.
I've tried a metal flexible snake thing but that didn't work. Plunging doesn't work.
Ideally I could put drain rods down the top of the soil...
See attached image. The extractor fan pipe goes into the cavity between walls. Not best photo, the rafter is hiding it going in above the inner wall.
I was told this setup is common. But this half of the attic has a soaking roof, it's dripping. You can top of rafters are wet. The other side (I...
I got a temperature monitor in and heated the room using a camping heater I have.
- 8:45am today was 12 degrees C (rest of house about 17 degrees - door to attic closed)
- Heated with a 1500W small camping heater for an hour - got to 16.5 degrees C
- Turned heater off, then 1 hour later was...
You mean the floor of the attic, so ceiling above bedrooms? Thats the same as its always been, which is about 100mm fibreglass insulation, they didn't do anything with that so should be the same as it was.
Does anyone think the 2 sheets of actis triso is good enough to retain heat? It doesn't seem very thick.
If it is, then I'm wondering if the veluxes are letting out all the heat?
Or it occurred to me that the end walls probably don't have cavity wall insulation like rest of the house as they...
Here's a video. Just shows a few thin sheets and where I put my fingers down under it I can feel the plasterboard
https://www.dropbox.com/s/fbwk80fgf8z8fxs/Loft%20Insulation.mov?dl=0
But the actis hybris 105mm looks like some sort of honeycomb system that's 105mm thick. I can't see that. But those sheets could be the actis tri-iso super 10.
The first image may be deceiving. The foil between my thumb and finger is the top of vertical kingspan on walls, not ceiling insulation.
It's supposed to be this as per drawings but I don't know. I can't see or feel anything that's 105mm thick. It's just a few of those silver sheeting things above plasterboard.