Recent content by madtrakz

That was the problem. Thanks for that. Much appreciated

The danfoss valve is heating the silver Honeywell is the hot water

I changed my fp715 with a fp720 and changed to back plates over. wired it up the same but i have no hot water. The red led lights up when the time it is set comes round but it doesnt show the tap symbol in the display. i changed to motorised valve with a new spare I have. wondering if its...

at work I remove old, weld on new and stone chip a sill in 3 hrs a side of that's an idea of cost for you. sills are around £20 each

Looking to change my Danfoss 24hr timer to a 24hr 7 day one. What model would you recommend to use. I don't want anything too technical and don't want a thermostat on it as it's in the kitchen. Seen a Danfoss one with a thermostat built into it.

The boiler runs fine on the heating cycle. On the hot water cycle it started to play up by purging and trying to ignite 3 or 4 times before running properly. Now it doesn't do anything when the timer clicks on for the water to heat.

Yes I have 2 x 2 way valves one of which I had to replace last winter as the heating circ pump wouldn't stop runing. The one I didn't replace is a Honeywell.

Hi, I have a Tranico oil fired boiler and a Megaflo system fitted in my house. The system started playing up a couple of weeks ago. When the timer cut in for the water to heat the boiler would start and stop a few times before running normally, just liken the boiler wasn't igniting. It is now...

Just got a yellow and blue wire, both sleaved red in the L1 and L2 terminals and a red wire in the common terminal.

I have 3, 2 way switched lights in my garage and want to add another light but to be 1 way switched. I have run a 2 core and earth cable from the new light into one of the switch boxes and have changed the single switch for a double 2 way switch and re-connected the main lights back as they...

Took the danfoss valve apart (electrical part) and cleaned out dust with hoover and sprayed with WD40 and system now working A OK. Thanks for your help saved me a few quid no dout.

Its a Eurostar. And I have just carried out the above test and it is the Danfoss valve at fault. Are they common to be faulty? If so what would be the best make to replace it with?

Yes one is a danfoss and the other is a honeywell.

How do you test the motorised valve, I think there are two in the airing cupboard. Can I manually turn them off?

I have just started having a problem with my heating/hot water system. The circulation pump in the airing cubard has started to run all the time no matter what I do with the thermostat or control panel. Only thing that shuts it down is to switch off the main switch next to the boiler in the...